PC board processing is not unfamiliar to us, many parts of daily life have to use the PC board, so it is not a rare commodity. PC plate using a wide range, then there is a corresponding PC board processing. Today, we have to say for everyone is the PC board processing! For PC board processing you know how much? I believe you have no number, but it does not matter, the Shanghai-resistant PC board manufacturers to explain it for everyone to explain it!

In general, any commodity processing is not possible overnight, have some need to pay attention to the place, otherwise it can not be called skills, PC board processing, what matters attention to it? Today to open for everyone Mysterious veil!

To know the attention of processing matters, we must first understand the PC board processing methods are what? PC board processing there are 3 ways:

1, sagging law, to see the name we can see this is from the bottom of the nose leads to the method is called sagging;

2, flat blowing method: This method is stored and the nose to find a center line, and then through the center line so that it is at the same level of the process can be called flat blowing;

3, on the cited method: This method is to PC board processing in the head of the top, after the top of a traction, and then PC board production process is called on the cited method.

Above we know the PC board processing of the three methods, after these three methods we can also know what its attention in the end.

1, it is necessary to pay attention to the thickness of the PC board processing how, preferably in a uniform value; if uneven, then the PC board processing will be unlucky, so the thickness of just, as long as the reach of even enough to PC board processing in a very good condition;

2, inflation: PC board processing this need to pay attention to adjust the wind speed, and open the same fan, too low is not good, too high is not good; let's take a central value just fine. In this link we should pay attention to is to adjust the position of the cooling valve, control the amount of wind out of the wind, the demand we have a certain experience to do;

3, PC board processing also need to pay attention to the small details such as temperature, gap width is how; production thickness of these are how the resolution of PC board processing of the elements of victory or defeat, so the production process must pay more attention.